Compression Poly Metric End Cap 110mm - Norma
Compression Poly Metric End Cap 110mm - Norma

POLY COMPRESSION METRIC END CAP 110MM - NORMA

Poly compression metric end cap 110mm - NORMA used to blank off the end of 110mm PE metric pipe in irrigation, rural water and general PE pipe systems.

✓ 110mm Metric End Cap
✓ Suits PE Metric Pipe
✓ Poly x Blank Connection
✓ WaterMark Approved
✓ Pressure Rating 1250kPa
✓ Check Pipe Size Before Ordering

Norma Metric Compression Fittings Brochure

More Information
Product Specifications
Compression Poly Metric End Cap 110mm - Norma
POLY COMPRESSION METRIC END CAP 110MM - NORMA
Compression Poly Metric End Cap 63mm - Norma
Compression Poly Metric End Cap 63mm - Norma CONMEC063
$21.54 /each
Compression Poly Metric End Cap 75mm - Norma
Compression Poly Metric End Cap 75mm - Norma CONMEC075
$47.56 /each
Compression Poly Metric End Cap 90mm - Norma
Compression Poly Metric End Cap 90mm - Norma CONMEC090
$66.58 /each
Compression Poly Metric End Cap 110mm - Norma
Compression Poly Metric End Cap 110mm - Norma CONMEC110
$114.53 /each

Poly compression metric end cap 110mm - NORMA is used to blank off the end of 110mm PE metric pipe in irrigation, rural water, mains water connection and general PE pipe systems. It provides a compression blanking point where a 110mm metric poly pipe run needs to be temporarily or permanently capped.

This 110mm NORMA metric end cap suits PE metric pipe made in accordance with AS/NZS 4130. It uses blue metric identification ends and an easy insertion compression design. The 110mm size is rated to 1250kPa. Confirm the pipe size, pressure rating and application requirements before ordering.

Norma Metric Compression Fittings Brochure

✓ Product Type & Size
Poly compression metric end cap, 110mm.

✓ Connection
110mm poly x blank metric compression end cap.

✓ Application
Used to blank off the end of 110mm PE metric pipe.

✓ Pipe Compatibility
Suitable for PE metric pipe made in accordance with AS/NZS 4130.

✓ Pressure Rating
1250kPa.

✓ Approval
WaterMark approved.

✓ Installation
Cut pipe square, deburr if required, mark the insertion depth, insert the pipe fully and tighten the nut until the mark is only just visible.

✓ Material
Polypropylene copolymer body, nut and holder with NBR metric O-ring and acetal clinching ring.

✓ Suitable Use
Suitable for irrigation, rural water, mains water connection and general PE metric pipe systems where the fitting size, pressure rating and installation requirements suit the application.

You may also like

Recently viewed