Lowara 2GS15 is a 1.5kW multistage bore pump for irrigation, tank filling and water supply. Performance is 30L/min at 146m head. This version uses a 380-415V three-phase supply.
Flow and head describe the same hydraulic performance point at approximately 2900rpm, 50Hz. Actual flow depends on pumping lift, required outlet pressure and pipe resistance. Use the matching performance curve to assess expected flow for the installation.
The outlet is 32mm (1 1/4") BSP female thread. A built-in non-return valve reduces backflow when the pump stops. These pumps handle clean bore water with up to 150g/m3 of sand.
A suitable external starter and motor overload protection are required. Motor overload protection must match the current on the included motor nameplate.
For automatic tank filling or pressure operation, connect suitable level or pressure controls. Use dry-running protection where a falling water level could expose the pump. Extend the motor lead with correctly sized submersible cable and a suitable waterproof joint. Secure the cable to the delivery pipe every 2-3m.
Install with the motor below the pump and keep the complete assembly submerged. While pumping, keep at least 1m of water above the pump outlet. Allow at least 3mm difference between the pump outside diameter and the bore internal diameter, with room for the cable and fittings. Position the pump clear of the bore bottom and accumulated sediment. Support it using suitable pipework and installation hardware. Never lift or suspend it by its electrical cable.
Water temperature is limited to 35°C. Water must move around the outside of the motor at least 0.08m/s (8cm/s) to remove heat. Fit a cooling sleeve if the installation cannot provide that flow, including unsuitable wide-bore or tank arrangements. Keep the pump submerged and do not run it dry.
The pump casing, shaft, strainer and cable guard are stainless steel, with a cast stainless-steel discharge head and motor adapter. Floating PPO technopolymer impellers and diffusers help resist sand wear, while the built-in stainless-steel non-return valve reduces backflow when the pump stops.
Suitable clean-water geothermal or fountain installations also require the correct motor cooling, submergence and controls.
Two-year warranty, subject to the applicable Australian Lowara supply terms and consumer rights.
Lowara 2GS Official 50Hz Performance Curve
Lowara e-GS Technical Data & Installation Guidance
