Orange Pumps CP400SL stainless steel transfer pump
Orange Pumps CP400SL stainless steel transfer pump
Orange Pumps CP400SL stainless steel transfer pump

ORANGE PUMPS CP400SL STAINLESS STEEL TRANSFER PUMP

The CP400SL is a centrifugal transfer pump for tank filling, washdown and low-pressure irrigation. It has a 5mm cast stainless steel casing.

✓ Approx. 110LPM at 20m head
✓ Pump and motor. Select automatic controls and a pressure tank separately if required.
✓ 1" pump inlet and outlet

Orange Pumps catalogue

Orange Pumps installation instructions

Orange Pumps CP400SL stainless steel transfer pump

Start with the flow you need at the outlet. Allow for the height the water must rise and the losses through pipes and fittings, then check the working point on the pump curve.

Compare CP200 and CP400 when cast iron suits the installation. CP400SL has a cast stainless steel casing. The 20m figures in the summary give a common comparison point. The chart shows how flow changes at other heads.

Allow for separate controls if the pump needs to start and stop automatically.

Fill the pump casing and suction line with clean water before starting. Keep suction joints airtight. Fit a foot valve at the intake for suction lift or a long suction line, following Orange’s installation instructions.

Orange Pumps catalogue
Orange Pumps installation instructions

✓ Application
Orange Pumps CP centrifugal transfer pumps move clean water for tank filling, washdown and low-pressure irrigation. CP200 and CP400 have cast-iron casings; CP400SL has a cast stainless steel casing.

✓ Model Specifications
CP400SL
Manufacturer motor rating: 1000W.
Current: 6.5A.

✓ Connections
1" pump inlet and outlet.

✓ Performance
Approximately 110LPM at 20m head, read from the manufacturer’s curve.
Use the performance chart to select the pump for the flow required at the working head, allowing for pipe friction and height differences. Maximum flow and maximum head occur at different operating points.

✓ Supplied Operation & Protection
These are pump-only models. They do not automatically start and stop as taps open and close. Automatic operation requires suitable separate controls. Built-in motor thermal protection does not provide a substitute for dry-run protection.
Pressure controller and pressure tank not included.

✓ Construction
CP200 and CP400: cast-iron pump casings. CP400SL: 5mm cast stainless steel casing. Nylon hydraulic internals, stainless steel motor shaft and carbon/ceramic shaft seal.

✓ Water Supply
Use clean water. Maximum published fluid temperature: 65°C. Select the pump for the water quality and operating conditions; refer to the installation guide.

✓ Installation & Priming
Fill the casing and suction line with clean water before starting. Keep suction connections airtight. For suction lift or a long suction line, Orange specifies a foot valve at the intake to retain prime. Follow the installation instructions for the valve arrangement.
Mount securely with supported pipework. Protect the pump from rain, flooding, frost, dust and pests while allowing motor heat to escape. Select suction pipework and pump location to minimise inlet losses.

✓ Electrical Supply
Single-phase pump supply; check the nameplate for the voltage. IP55 motor enclosure with built-in thermal protection. Manufacturer motor ratings are listed above; use the supplied nameplate for the installed unit's electrical details.

✓ Warranty
Two-year Orange Pumps pump warranty, subject to manufacturer terms.
Graph image for Orange Pumps CP400SL Stainless Steel Transfer Pump

Recently viewed