Grundfos SP 11-3 supplies clean groundwater for domestic water systems, irrigation and pressure boosting, with a rated flow of 11m3/h (183.3L/min) at 13m head. This rated duty describes flow and head together. Actual flow depends on pumping lift, required outlet pressure and pipe resistance; the matching 50Hz curve helps assess expected flow for the installation.
The outlet is 50mm (2") Rp / BSP female thread. The pump handles clean, thin, non-aggressive water with a maximum sand content of 150g/m3. A built-in non-return valve reduces return flow when the pump stops.
240V single phase, two wire. Starting equipment is in the motor.
For automatic operation, connect suitable tank-level or pressure controls. Where the water level could fall below the pump inlet, use dry-running protection to stop the pump before it draws in air. Extend the motor lead with correctly sized submersible cable and a suitable waterproof cable joint for the installation depth.
Keep the pump inlet submerged below the lowest water level reached while pumping. At least 0.5m of water above the inlet is recommended; greater submergence may be needed to maintain adequate pressure at the inlet. Maximum installation depth is 150m below the water surface. Install vertically with the motor below the pump and support the assembly with suitable pipework and installation hardware. Do not lift or suspend it by its electrical cable.
Liquid temperature is +2 to +40°C. Water must flow around the motor to remove heat. Follow the cooling requirements of the included motor. Fit a cooling sleeve if the installation cannot provide the required flow. Keep the pump and motor submerged. Do not run dry.
The pump and impellers are AISI 304 stainless steel. Multiple impeller stages build head through the pump, while water-lubricated bearings support the rotating assembly.
Manufacturer warranty terms and applicable consumer rights apply.
SP 11 Official 50Hz Performance Curve
SP Installation & Operating Instructions
